Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Inspection and Verification - Engine Performance

Inspection and Verification - Engine Performance
There are 2 diagnostic paths that can be followed depending on the type of engine concern. Carry out either the Inspection and Verification - Engine Performance or Inspection and Verification Noise, Vibration and Harshness (NVH). Inspection and Verification - Noise, Vibration and Harshness (NVH)

1. Verify the customer concern by operating the engine to duplicate the condition.
2. Visually inspect for obvious signs of mechanical damage. Refer to the following chart.

Visual Inspection Chart

Visual Inspection Chart:





3. If the inspection reveals obvious concerns that can be readily identified, repair as necessary.

4. NOTE: Make sure to use the latest scan tool software release.

If the cause is not visually evident, connect the scan tool to the data link connector (DLC).

5. NOTE: The vehicle communication module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.

If the scan tool does not communicate with the VCM:
^ check the VCM connection to the vehicle.
^ check the scan tool connection to the VCM.
^ refer to Information Bus (Module Communications Network) to diagnose no communication with the scan tool.
6. If the scan tool does not communicate with the vehicle:
^ verify the ignition key is in the ON position.
^ verify the scan tool operation with a known good vehicle.
^ refer to Information Bus (Module Configuration) to diagnose no response from the PCM.
7. Carry out the network test.
^ If the scan tool responds with no communication for one or more modules, refer to Information Bus (Multiplex Communications Network).
^ If the network test passes, retrieve and record continuous memory DTCs.
8. Clear the continuous DTCs and carry out the self-test diagnostics for the PCM.
9. If the DTCs retrieved are related to the concern, refer to Body Control Systems (Multifunction Electronic Control Module).
10. If no DTCs related to the concern are retrieved, GO to Symptom Chart - Engine Performance. Symptom Chart - Engine Performance